Inventory Pick/Drop

How to use the Pick/Drop feature

David Andrade avatar
Written by David Andrade
Updated over a week ago

Autodesk Fusion Operations allows you to manage your inventory. It gives you the possibility to perform ‘Internal Inventory Movements’ through the back-office or with your mobile device.

When you want to do ‘Internal Inventory Movements’ with your mobile device, there are two options:

1. Use ‘Inventory Move’ to move them instantly;

2. Use ‘Inventory Pick/Drop’ to register when the operator picks the item from its current location and drops it in the new location.

When should you use ‘Inventory Move’ or ‘Inventory Pick/Drop’?

The main difference between ‘Inventory Move’ and ‘Inventory Pick/Drop’ is that, while in ‘Inventory Move’ you can only choose one pick and one drop location, in ‘Inventory Pick/Drop’ you can choose more than one pick and drop locations.

Also, in ‘Inventory Move’, the movement of the products is instantly, while in ‘Inventory Pick/Drop’ you can pick the products in one moment and drop them later.

This allows you to track the transportation timing from one location to the other.

Setup your mobile device to configure the ‘Inventory Pick/Drop’ button and make it available.

After doing this the ‘User’ can select ‘Inventory Pick/Drop’ on the mobile device.

Select if you are Picking or Dropping material.

After, you can select the Warehouse and the Warehouse location you are Picking/Dropping from/to. Additionally, you must choose as well the ‘Product’, ‘Quantity’ and ‘lot/batch number’ you are moving.

At the end, you can choose to add another product that you are moving and keep going or close and finish the Pick/Drop movement.

Need help? Request a Fusion Operations expert to contact you here.

Did this answer your question?